For more information on accessibility, access procedures and deadlines, see our Training page.
CQI-11 – Evaluation of special surface treatment processes: the method – #2511
1,190.00 € HT
Context
- You wish to understand the applicable customer requirements according to the CQI-11 self-assessment manual (AIAG) on the control of the special surface treatment process and the self-assessment rules.
Objectives
- Understand the specific requirements of customers demanding CQI-11.
- Discover the contents of the CQI-11 manual (self-assessment tables, job audit, etc.).
- Identify the key points in the manual.
- Learn how to use the self-assessment questionnaire in the CQI-11 manual through a case study on technical aspects.
Recommanded for
- Quality / QHSE managers, engineers and technicians.
- Quality engineers.
- Methods engineers.
- Internal auditors.
- Customer of a supplier subject to CQI-11.
Prerequisites
- Understanding how a surface treatment plant works.
Specific operating conditions for remote sessions
- Have a PC equipped with a microphone, webcam and, if possible, a headset for greater comfort. Note: To blur or hide the view from behind, background screens are available in Zoom or Teams.
- A good Internet connection, tested before the session.
- Locate in a quiet, isolated area; switch to “not available” status in Teams; close your email access and mute your phone to avoid distraction during the session.
- To avoid off-topic discussions during the session, participants from the same organisation should not be grouped together in the same room, but rather at their own desks. Virtual sub-groups will be set up specifically for the exercises, which will also allow for mixed groups to be created.
- The webcam and microphone must be open during remote qualification/certification exams. It may also be necessary for us to check that you are the only one in the room.
- We ask that you connect at least 5 minutes before the beginning of the session.
Pedagogy
- The teaching method alternates between theoretical sequences on the requirements of the CQI-11 manual and application sequences through a case study on the technical aspects.
Evaluation mode
- Knowledge test (MCQ).
Course materials
-
Participant file containing the presentations delivered during the training and the exercise materials.
To go further
Trainings :
Consulting services : EURO-SYMBIOSE can assist you in the concrete implementation in your company. Contact us to know more about it.
Session 1
General Introduction.
Session 2
Section 1: Management responsibility and quality planning.
Session 3
Section 2: Responsibility for ground handling and materials.
Session 4
Section 3: Pyrometry.
Session 5
Process Table A: Zinc and zinc alloys.
Session 6
Process Table H: Hydrogen embrittlement treatment.
Session 7
Process Table D: Decorative coating of plastic substrates.
Session 8
Process Table I: Process control and verification and calibration of test equipment.
Session 9
Section 4 of the PSA: Job audit.
Votre référent :
François DUJARDIN
Specialty: quality assignments in the automotive sector.